Fill-in reflector
Light diffusing panel
Wireless flash sensor
Flash head
AF-assist light
Accessories: Flash stand, Pouch
Pilot lamp (Test flash button)
On / Off switch (Press button)
Mode select button / indicator
(TTL→Manual→Slave 1→Slave 2)
Flash power level indication lamps (6 LEDs)
Flash power level select button
Lock ring
Mounting foot
Hotshoe contacts
Battery magazine
Nomenclature
Flash stand
Filter
guide
12-53
For 4/3 Digital Cameras
NOTE
Remove the battery magazine and
insert 4 x size AA batteries as shown
in the picture.
The battery compartment is designed
so that each cell is placed in same
direction to avoid the confusion in
poor light situation.
It is recommended to use all 4 batteries in same brand and type, and
replace them all at the same time. Wrong insertion of each cell does
not make electric contact.
+ / - symbol is clearly marked at the
battery compartment.
Place the battery magazine back
into the body.
Basic Operation
Inserting batteries
Mounting Di466 Four Thirds on the Camera
Removing Di466 Four Thirds from the Camera
NOTE
Before mounting or removing Di466 Four Thirds into or from the
camera, it is recommended to turn off the power switch of both Di466
Four Thirds and the camera.
Loosen the lock ring and slide the mounting foot of Di466 Four Thirds off
the hotshoe of the camera. Make sure to turn the lock ring all the way to
completely clear the lock pin off the hooking slot on the hotshoe.
Slide the mounting foot of Di466 Four
Thirds into the hotshoe of camera.
Turn the lock ring to loosen it as shown in
the picture.
Turn the lock ring to opposite direction
and tighten it.
Lock pin comes out to hook the foot at
the hotshoe for sure contact.
Turn on the flash unit
To save battery energy, the power is automatically turned off (to
stand-by mode), both in TTL mode & Manual Power mode, in about 2
minutes of idle use.
While Di466 Four Thirds is in the stand-by mode a Pilot lamp blinks
every 2 seconds showing the flash unit is in stand-by mode.
To turn on Di466 Four Thirds again, press the camera’s shutter button
halfway or press any button of the flash unit.
In case Di466 Four Thirds is not in use over 30 minutes, the unit is
completely turned off and shut out the current leakage from the
batteries.
To turn on Di466 Four Thirds again, take the first step of turning the
flash unit on.
In case of using Di466 Four Thirds as a slave flash (at slave mode*5),
Di466 Four Thirds will not go into the stand-by mode. It will however
automatically turn off when not used over 60 minutes.
*5: Slave mode : Refer instruction below.
Di466 Four Thirds has energy saving double power off function.
For a test flash, press the Pilot lamp. When using the test flash as an
open flash, please note that the reference guide number in this case is
G.No.10 (ISO 100).
To turn off the flash unit manually, press the On / Off switch for 2
seconds.
Press the On / Off switch and Pilot lamp
turns red showing the unit is turned on.
In a few seconds, the Pilot lamp turns
green. Di466 Four Thirds is ready to shoot.
(11 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals