Nissin Di700A Nikon Instruction Manual download pdf (Page 9)

Shooting Di700A automatically

Canon cameras

Nikon cameras

(Program), (Full Auto), (Aperture priority),

(Shutter priority) or (Manual);

(Program), (Full Auto), (Aperture priority),

(Shutter priority) or (Manual);

Set Di700A to the camera’s hotshoe and press the on/off switch to

power on.

Rotate the dial to “A” mode then press the Set button.

Di700A is now set for the camera’s automatic flash control system.

Press the shutter button of your camera halfway to focus the subject.

Press the on/ off switch once again to lock this condition on your

flash. (Press it again to release the lock)

Take the picture. Di700A is fired and the result is immediately

shown on the camera’s LCD display.

When you change the focal length, the power zoom flash head of

Di700A responds without delay and immediately sets its position to

match the lens focal length you selected.

The flash illumination coverage of Di700A responds to the lens focal

length of 24mm to 200mm (35mm film camera standard).

In all of the camera's shooting modes listed above, Di700A will fully

work in TTL (ETTL, ETTL-II for Canon and i-TTL for Nikon)

automatic-flash system.

Shutter speed, aperture and flash mark ( ) are indicated in

camera’s view finder.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 24 25

No comments

Nissin Di700A Nikon Instruction Manual Page 9